Electronic product anti-static facilities

Reading：102

??1.Static safety workbench a.Static safety workbench is the basic component of the anti-static work area.It consists of a workbench,an anti-static table mat,a wristband joint and a grounding wire.b.There should be no less than two wristband connectors on the anti-static table mat,one for the operat..

The effect of liquid impurities on static electricity

Reading：101

The effect of impurities on the charging of liquid media has also been found in production.For example,there has been a sudden and substantial increase in the amount of static electricity that has occurred in some oil products,and this has caused an electrostatic accident.

Factory common error anti-static method

Reading：100

In many factories,we use a lot of anti-static products,why are static damage often occurring?The following article describes the common anti-static methods commonly used in factories.

Antistatic material introduction

Reading：101

1.Electrostatic conductor One has a lower resistivity unless it is insulated from the ground,where it is difficult to accumulate an electrostatic charge.

What are the PE protective films?

Reading：100

According to the density:PE protective film is mainly made of special polyethylene(PE)plastic film,and then divided into high density polyethylene protective film,medium density polyethylene and low density polyethylene according to the density.

What are the characteristics of PET release film?

Reading：100

PET release film application scale:PET release film is mainly used in electrical,insulation,packaging,magnet containers,film,tape,floppy disk,film,video and entertainment software;its application is extensive,such as bronzing film,aluminum plating Film,printing film,packaging film,packaging material..